Site Map

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

boiler roomboiler room

Economical Space

As a modular system, The Skid step-fires only the boiler modules required during a specific period for heating, snow melting, ventilation and the domestic water requirements of a facility. The system and piping operate at the same temperature to save energy.

When systems and integral gas fired equipment are individualized, there is little savings on fuel consumption or servicing, because many high-output gas-fired systems must operate at a high temperature at all times. Modular systems save energy over time by firing up only those modules required . These savings become more pronounced when the internal systems are coordinated to eliminate unnecessary water storage.

While building control systems are compatible with our plant's controls, we recommend a complete review of the existing control system where The Skid is utilized, as a retrofit into existing building systems. We also recommend a complete water balance for optimum efficiency of hot water heating and associated system in a facility.

The system requires only a small section of space, but creates an enormous amount of output heat and cool air.

A few of the impressive features of The Skid are; the redundancy keeps the system going non-stop, even if one of the modules breaks down. Also it has the capability to restore heat in a building in just a few hours, even after there has been an all night power outage.

The basic design of The Skid includes the following:

* No less than three system modules (allowing for redundancy)

* Pumps

* Domestic hot water storage tanks and/or heating exchanger and mixing valves

* Domestic water treatment, softeners, and/or filters

* Expansion tanks

* Heating supply and return, domestic water, fuel and relief piping

* Electrical power and control wiring

* Base skid (housekeeping pad)

* All required operation and control devices with panels for a fully operational system plant

* All-inclusive system space building (where required)

* Mechanical concept design and mechanical project management services (where required)


System Integrity and Control